98 Up JMod Instructions

Motor and Trans Q/A
Post Reply
OU812
Posts: 4
Joined: Thu Dec 07, 2017 4:11 pm

98 Up JMod Instructions

Post by OU812 » Fri Dec 15, 2017 7:17 pm

I did not create the jmod instructions. I used this in conjunction with the Transgo Kit. Worked really well. Didnt have to jack the line pressure to the moon.
Derale Trans cooler
-6 Trans cooler lines - Make sure you get the right fittings to screw into the trans to adapt to the cooler lines. they need to be straight pipe thread. I think they call it BPT. I also switched to a Lokar Trans dip stick tube. I should have gotten one a tad longer. it is much easier to access than the stock tube.
Valvoline MaxLife ATF - Full Synthetic - Run it in all my vehicles and all the work I do for others. Use it for power steering fluid quite often also.
4K CirlceD convertor $1K in case ya need to know.
Also did the tail shaft lube mod. it has 4.10s out back so you are suppose to add some extra lube back there. I pulled the tail shaft housing off and put a new bushing in at the same time.
Attachments
20170316_214402127_iOS.jpg
20170316_214348593_iOS.jpg
20170316_214302087_iOS.jpg
20170304_214909000_iOS.jpg
Trans Fluid Temp Sensor
20170304_223040000_iOS.jpg
20160206_230515588_iOS.jpg
20160206_200229963_iOS.jpg
20160206_200214886_iOS.jpg
20160206_161539571_iOS.jpg
98 up Jmod.pdf
98 Up JMod Instructions
(396.38 KiB) Downloaded 3 times

lance_b
Posts: 13
Joined: Tue Oct 24, 2017 2:28 pm
Location: Dallas TX

Re: 98 Up JMod Instructions

Post by lance_b » Fri Dec 15, 2017 8:19 pm

VERY helpful!!! Thanks again!! :mrgreen:
- Lance 1996 LSC, Turbo
Image

Post Reply